AMD’s Brazos vs. Atom Thermals, Revisited

Last week, we met with AMD at their CES location to see some of their upcoming systems and laptops. While they’ve also recently released several new desktop GPUs, there wasn’t anything new to discuss in that area. The same applies to their desktop CPUs—we’re all waiting to see Llano and Bulldozer. So the focus at CES was understandably on Brazos, aka the “first APU” Vision C- and E-series processors.

We’ve been critical of some of the staged platform comparisons we’ve seen in the past—as Anand put it, the onus is on AMD in this case to provide a truly representative comparison between their new product and Intel’s competing offerings. After the demonstration of their Brazos netbooks on Thursday, AMD called us back and said they wanted to let us rerun the tests to make sure we accurately represented the two platforms. See, there was a slight snafu in the initial thermal imaging comparison. Specifically, AMD thought they put out a netbook with a C-50, but the test system was actually a C-30. So, we returned….

The reason for the mix-up was simple: they had both a C-30 and C-50 system from the same OEM, and they’re basically identical (one was dark blue and the other was light blue). Given that the two C-series parts are both 9W TDP, we didn’t expect much to change, and the new testing confirmed this. We did get some better images of both the top and bottom of the three test netbooks—Atom N550 vs. C-30 and C-50. Unfortunately, stupidity on my part resulted in the loss of said images (it’s a long story…), so all we have are the thermal shots from the keyboard area and screenshots showing CPU utilization during playback along with screen captures taken with FRAPS.

The above gallery shows essentially the same thing as our initial testing: Brazos using its GPU uses less power and runs cooler than Atom N550 doing the decoding in software. The difference between the C-30 and C-50 is pretty much non-existent, as expected. The testing environment was not conducive to doing any form of noise comparison, so while the N550 setup was clearly warmer we couldn’t say if it was quieter or not. Battery life is looking to roughly equal Atom, so that’s good to see. Now we’re waiting for final hardware to see if we can shed any more light on the situation, as well as running our full suite of tests.

We also took the opportunity to capture a video showing the 1080p playback comparison, as that’s part of the story. The video in question is Big Buck Bunny, an open movie demo created as part of the Peach movie project. (You can read more about it on their site, though it’s old enough now that if you haven’t heard of it already there’s not much to add. Suffice it to say, the lack of any licensing issues meant BBB was all over the CES floor, and I’m tired of the short now!) This particular version is a stereoscopic rendering, so instead of the normal 24FPS the frame rate is 48FPS according to FRAPS.

I believe during playback Arcsoft TotalMedia Theater 5 is skipping half the frames, as none of the netbooks come equipped with a 3D 120Hz panel. Does that actually matter? Not that we could tell—now that we’re home from CES, I ran the regular 24FPS version of Big Buck Bunny on a different dual-core N550 netbook, and frame rates still frequently dropped into the teens. Actually, it was worse than the netbook at AMD’s demonstration, but that’s probably more to do with lack of optimizations and some bloatware that came preinstalled; but I digress….

You can see during playback that the Atom N550 periodically stutters and drops below 48FPS—and more importantly, it’s far below 24FPS as well at times. In comparison, both the Vision C-30 and C-50 Brazos/Ontario chips manage a consistent 48FPS. The C-30 does flicker between 47 and 48FPS, but again, that may simply be an artifact of using a stereoscopic 3D video on a non-3D panel. Temperatures are in line with what we reported in our earlier coverage, and the two AMD netbooks are virtually identical. CPU utilization on the dual-core C-50 is lower by about half, as expected.

Once More, With Feeling

This is essentially the killer app of Brazos compared to Atom, and it’s important to keep things in perspective. These chips have a much better IGP than Atom, but at least on the nettop side of things the faster AMD E-350 isn’t miles ahead of Atom D510 in the CPU department. When we drop clock speeds down to 1.0GHz (dual-core C-50) from 1.6GHz (E-350) and compare that to the Atom N550 (1.5GHz)… well, 62.5% of the performance of E-350 compared to 90.4% of the performance of D510 means that in some tests the N550 will probably beat the C-50 for raw CPU potential. Yeah, that’s a concern for me. The GPU is the real difference, so naturally a video decoding test is the best-case scenario. I suspect C-50 will be underpowered for most 3D games, even if the DX11 GPU inside Brazos is fast enough—it will just be the AMD equivalent of Atom + NVIDIA ION, only without as many discrete chips.

We also have to consider performance of the next tier of CPUs and IGPs. Atom is the lowest of the low hanging fruit; we have much faster chips and IGPs from both AMD and Intel, and we don’t need to move up to current generation parts like 2nd Gen Core processors. Even the old Core 2 Duo CULV chips are a darn sight faster than Atom (2x-3x faster), and bad as GMA 4500MHD is, it could do an okay job at H.264 offload. It appears that the E-350 will end up delivering performance roughly equal to the old CULV chips (probably a bit slower, to be honest). That means it will also be around the same level as the Athlon II Neo K325, only with a better IGP and apparently improved power characteristics.

The biggest point in favor of Brazos isn't performance, though. It's going to be cost. If AMD can get partners to put out $400 netbooks (hopefully without Win7 Starter and with more than 1GB RAM), that will hopefully put the nail in the current iteration of Atom. We've seen the Brazos chips, and they're extremely small—smaller even than Atom—so pricing should be very compelling. AMD also doesn't appear concerned about protecting their more expensive mobile offerings (mostly because there aren't many), so they don't have to castrate Brazos in the same way Atom has been stagnant since the first N270 rolled out. Well equipped Brazos netbooks (and nettops) in the $500 range should also be a more elegant choice than Atom + ION/NG-ION, so again AMD looks set to win several matchups.

We’re working to get Brazos hardware in for testing as soon as possible, but it looks like the biggest beneficiaries will be users that want good H.264 decoding in a 10.1” form factor, or an alternative to ION. If you’re looking for the ultimate HTPC chip, we’ll have to investigate that area in further detail, as bitstreaming support and other features are still a question mark. Right now, Brazos is shaping up to be what we all wanted from Atom last year; whether that will be enough in 2011 remains to be seen.

Comments Locked


View All Comments

  • SeetheSeer - Friday, January 14, 2011 - link

    I don't mean to be rude, but I'm curious why you are constantly fixated on bitstreaming support for HTPC's. Why is it any better than 5.1 channel LPCM? The only difference I've managed to find between the two are vague, superstitious assertions that LPCM is harder to sync correctly with the video than bitstreaming. In fact, LPCM actually has one advantage: you can mix in overlaid sounds, such as commentary, which AFAIK is impossible with bitstreaming.
    Confused Seer
  • n0b0dykn0ws - Friday, January 14, 2011 - link

    The reason is that without a protected audio path, or stripping the DRM, audio quality is reduced when it is decoded and PCM is sent over HDMI.

    I'm not sure about PCM when a PAP is available, but when native Dolby TrueHD and DTS HD Master Audio are bitstreamed to a compatible audio receiver there is no quality loss (outside of what is done by the AVR).

    Between the two, blu-ray owners prefer the lossless option. Lossless PCM versus lossless DTHD/DTSMAHD decoding at the AVR level is equal otherwise, but not in this case.

    I don't think the PCM route will ever be 'fixed', at least not without jettisoning DRM, which is unlikely.

  • heffeque - Friday, January 14, 2011 - link

    You mean DRM protected movies. Normal HD movies downloaded on P2P networks don't have that problem.
  • Taft12 - Friday, January 14, 2011 - link

    I am strongly against copyright infringement, but this is such a good example of how content providers are providing an inferior product to the illegal alternative. It is a huge, huge problem in the industry.

    I paid for a DVD, why must I sit through FBI warnings and deal with down-converted output when a less legitimate copy does not have this nuisance?
  • knedle - Sunday, January 16, 2011 - link

    Yeah, it's like "you bought a movie, so now you can download pirated version and get everything you paid for"
  • Zoomer - Sunday, January 16, 2011 - link

    Wouldn't AnyDVD fix the problem?
  • Dribble - Monday, January 17, 2011 - link

    That's what I had to use to play my perfectly legal copy of Inception using my laptop with my fully patched fully legal bluray software.
    I think I should charge the bluray consortium for my copy of AnyDvD because it's only only way I can play back my legally owned films!
  • SeetheSeer - Friday, January 14, 2011 - link

    Yes, but so long as you use HDMI you have that PAP. And all of the points in question have been about LPCM over HDMI. So that doesn't really answer the question.
  • OCedHrt - Saturday, January 15, 2011 - link

    I had always assumed that the AVR may do a better decoding of the encoded audio. I'm not sure if the decoding process is lossless for audio.
  • n0b0dykn0ws - Monday, January 17, 2011 - link

    Just because it is a HDMI connection does not ensure a PAP. Especially in older chips.

    If the solution can do LPCM over HDMI without reducing the quality one bit (or Hz) then most people wouldn't care. Bitstreaming ensures 100% quality intact.


Log in

Don't have an account? Sign up now